National-instruments Terminal Block NI TB-2706 Uživatelský manuál stáhnout pdf (Strana 3)

Connecting the Signals

Refer to Figure 1 as you complete the following steps to connect signals to your terminal block.

Figure 1. TB-2706 Parts Locator Diagram

1. Remove the terminal block cover by unscrewing the top cover screw using the 0.10 in. slotted

screwdriver.

Note Your kit contains a pinout label for M Series devices only, shown in Figure 2. This label,

adhered to the inside of the cover, is a pin number-to-signal name reference. For PXI-6143 pin

connections, refer to Figure 3 or the S Series User Manual.

1 Top Cover Screw

2 Cover

3 Chassis Ground Lug

4 Strain-Relief Screw

5 Terminal Block Mounting Screw

6 Strain-Relief Bar

7 Signal Wire

8 Strain-Relief Opening

9Base

10 Screw Terminals

11 Base Tab

12 Connection to PXI/PXIe Module

13 Cover Indentation

1 2 3 4 5 6 7 8

Žádné komentáře

National-instruments Terminal Block NI TB-2706 Uživatelský manuál Strana 3