National Instruments 5441 Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro Měření, testování a kontrola National Instruments 5441. National Instruments 5441 User's Manual Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 44
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 0
NI 5441 Specifications
NI PXI-5441 16-Bit 100 MS/s Arbitrary Waveform Generator
with Onboard Signal Processing (OSP)
Unless otherwise noted, the following conditions were used for each
specification:
Analog Filter enabled.
DAC Interpolation set to maximum allowed factor for a given sample
rate.
Signals terminated with 50 .
Direct Path set to 1 V
pk-pk
, Low-Gain Amplifier Path set to 2 V
pk-pk
,
and High-Gain Amplifier Path set to 12 V
pk-pk
.
Sample clock set to 100 MS/s.
Typical values are representative of an average unit operating at room
temperature (25 °C ± 3 °C). Specifications are subject to change without
notice. For the most recent NI 5441 specifications, visit
ni.com/manuals.
To access all the NI 5441 documentation, including the NI Signal
Generators Getting Started Guide, which contains functional descriptions
of the NI 5441 signals, navigate to Start»Programs»National
Instruments»NI-FGEN»Documentation.
Hot Surface If the NI 5441 has been in use, it may exceed safe handling temperatures and
cause burns. Allow the NI 5441 to cool before removing it from the chassis.
Contents
CH 0 ........................................................................................................ 2
Sample Clock .......................................................................................... 14
Onboard Clock ........................................................................................ 17
Phase-Locked Loop (PLL) Reference Clock .......................................... 17
CLK IN ................................................................................................... 18
PFI 0 and PFI 1 ....................................................................................... 19
DIGITAL DATA & CONTROL (DDC) ................................................ 20
Start Trigger ............................................................................................ 22
Markers ................................................................................................... 24
Zobrazit stránku 0
1 2 3 4 5 6 ... 43 44

Shrnutí obsahu

Strany 1 - NI 5441 Specifications

NI 5441 SpecificationsNI PXI-5441 16-Bit 100 MS/s Arbitrary Waveform Generator with Onboard Signal Processing (OSP)Unless otherwise noted, the followi

Strany 2

NI 5441 Specifications 10 ni.com0 ºC to 40 ºC Total Harmonic Distortion (THD)Path Amplitude –1 dBFS. Includes the 2nd through the 6th harmonic.DirectL

Strany 3 - Amplitude

© National Instruments Corporation 11 NI 5441 SpecificationsSpectral Characteristics (Continued)Average Noise DensityPathAmplitude RangeAverage Noise

Strany 4 - For the Direct Path:

NI 5441 Specifications 12 ni.comFigure 4. 10 MHz Single-Tone Spectrum, Direct Path, 100 MS/s, DAC Interpolation Factor Set to 4NoteThe noise floor in

Strany 5

© National Instruments Corporation 13 NI 5441 SpecificationsFigure 5. 10 MHz Single-Tone Spectrum, Low-Gain Amplifier Path, 100 MS/s, DAC Interpolati

Strany 6

NI 5441 Specifications 14 ni.comFigure 6. Direct Path, 2-Tone Spectrum (Typical)NoteThe noise floor in Figure 6 is limited by the measurement device.

Strany 7

© National Instruments Corporation 15 NI 5441 SpecificationsSample Rate Range and ResolutionSample Clock SourceSample Rate Range Sample Rate Resolutio

Strany 8

NI 5441 Specifications 16 ni.comSystem Phase Noise and Jitter (10 MHz Carrier)Sample Clock SourceSystem Phase Noise Density(dBc/Hz) OffsetSystem Outpu

Strany 9

© National Instruments Corporation 17 NI 5441 SpecificationsOnboard Clock(Internal VCXO)Phase-Locked Loop (PLL) Reference ClockSpecification Valu e Co

Strany 10

NI 5441 Specifications 18 ni.comCLK IN(Sample Clock and Reference Clock Input, Front Panel Connector)Specification Valu e CommentsConnector SMB (jack)

Strany 11

© National Instruments Corporation 19 NI 5441 SpecificationsPFI 0 and PFI 1(Programmable Function Interface, Front Panel Connectors)Specification Valu

Strany 12

NI 5441 Specifications 2 ni.comArbitrary Waveform Generation Mode ...25Function Generation Mode ...

Strany 13

NI 5441 Specifications 20 ni.comDIGITAL DATA & CONTROL (DDC)Optional Front Panel ConnectorSpecification Valu e CommentsConnector Type68-pin VHDCI

Strany 14 - Sample Clock

© National Instruments Corporation 21 NI 5441 SpecificationsOutput Signal Characteristics (Continued)Output Skew Typical: 1 ns, maximum 2 ns. Skew bet

Strany 15

NI 5441 Specifications 22 ni.comStart TriggerDDC CLK INClocking FormatDDC Data Output signals change on the rising edge of DDC CLK IN.—Frequency Range

Strany 16 - System Output Jitter

© National Instruments Corporation 23 NI 5441 SpecificationsDelay from Start Trigger to CH 0 Analog Output with OSP Disabled.DAC Interpolation Factor

Strany 17 - Onboard Clock

NI 5441 Specifications 24 ni.comMarkersSpecification Valu e CommentsDestinations 1. PFI<0..1> (SMB front panel connectors)2. PFI<4..5> (DI

Strany 18

© National Instruments Corporation 25 NI 5441 SpecificationsArbitrary Waveform Generation ModeSpecification Valu e CommentsMemory Usage The NI 5441 us

Strany 19 - PFI 0 and PFI 1

NI 5441 Specifications 26 ni.comMinimum Waveform Size (Samples)Trigger ModeArbitrary Waveform ModeArbitrary Sequence ModeThe Minimum Waveform Size is

Strany 20

© National Instruments Corporation 27 NI 5441 SpecificationsMemory Limits (Continued)Arbitrary Sequence Mode, Maximum Waveforms262,000Burst trigger: 3

Strany 21

NI 5441 Specifications 28 ni.comFunction Generation ModeSpecification Valu e CommentsStandard Waveforms and Maximum FrequenciesWaveform Maximum Freque

Strany 22 - Start Trigger

© National Instruments Corporation 29 NI 5441 SpecificationsOnboard Signal ProcessingFigure 7. Onboard Signal Processing Block DiagramSpecification V

Strany 23

© National Instruments Corporation 3 NI 5441 SpecificationsAmplitude and OffsetAmplitude RangePath LoadAmplitude (Vpk-pk) 1. Amplitude values assume t

Strany 24

NI 5441 Specifications 30 ni.comPre-Filter Offset Range–1.0 to +1.0 Applied after Pre-Filter GainOutput Output = (User Data × Pre-Filter Gain) + Pre-F

Strany 25

© National Instruments Corporation 31 NI 5441 SpecificationsSpecification Value CommentsFIR Filter TypesFilter Type Parameter Minimum Maximum —Custom

Strany 26

NI 5441 Specifications 32 ni.comModulation Performance (Typical)Modulation ConfigurationMeasurement Type FIR Interpolation —2 4 8GSM Physical Layer1ME

Strany 27

© National Instruments Corporation 33 NI 5441 SpecificationsSpecification Valu e CommentsDigital PerformanceMaximum NCO Spur< –90 dBc Full-Scale Ou

Strany 28 - Function Generation Mode

NI 5441 Specifications 34 ni.comFigure 8. GSM Physical Layer1 External Sample Clocking = 99.665 MHzFigure 9. GSM Physical Layer1Internal (High Resol

Strany 29 - Onboard Signal Processing

© National Instruments Corporation 35 NI 5441 SpecificationsFigure 10. CDMA 2000 Physical Layer1External Sample Clocking = 98.304 MHzFigure 11. CDMA

Strany 30 - (–1 ≤ Output ≤ +1)

NI 5441 Specifications 36 ni.comFigure 12. W-CDMA Physical Layer1External Sample Clocking = 92.16 MHzFigure 13. W-CDMA Physical Layer1Internal (High

Strany 31

© National Instruments Corporation 37 NI 5441 SpecificationsFigure 14. DVB Physical Layer1External Sample Clocking = 96.88 MHzArtifacts at 15 and 35

Strany 32

NI 5441 Specifications 38 ni.comCalibrationPowerSpecification Valu e CommentsSelf-Calibration An onboard, 24-bit ADC and precision voltage reference a

Strany 33

© National Instruments Corporation 39 NI 5441 SpecificationsSoftwareSpecification Valu e CommentsDriver SoftwareNI-FGEN 2.3 or later version. NI-FGEN

Strany 34

NI 5441 Specifications 4 ni.comAccuracyDC Accuracy For the Low-Gain or High-Gain Amplifier Path: ±0.2% of Amplitude ± 0.05% of Offset ± 500 µV (within

Strany 35

NI 5441 Specifications 40 ni.comEnvironmentNI PXI-5441 EnvironmentNote To ensure that the NI PXI-5441 cools effectively, follow the guidelines in the

Strany 36

© National Instruments Corporation 41 NI 5441 SpecificationsSafety, Electromagnetic Compatibility, and CE ComplianceSpecification Value CommentsSafety

Strany 37

NI 5441 Specifications 42 ni.comPhysicalSpecification Valu e CommentsDimensions 3U, One Slot, PXI/cPCI Module2.0 × 13.0 × 21.6 cm (0.8 × 5.1 × 8.5 in)

Strany 38 - Calibration

© National Instruments Corporation 43 NI 5441 SpecificationsTechnical Support ResourcesNI Web SupportNational Instruments Web support is your first st

Strany 39 - Software

National Instruments, NI, ni.com, and LabVIEW are trademarks of National Instruments Corporation. Refer to the Terms of Use section on ni.com/legal f

Strany 40 - Environment

© National Instruments Corporation 5 NI 5441 SpecificationsFrequency and Transient ResponseBandwidth 43 MHz Measured at –3 dB.DAC Digital Interpolatio

Strany 41 - CE Compliance

NI 5441 Specifications 6 ni.comFigure 1. Normalized Passband Flatness, Direct PathFigure 2. Pulse Response, Low-Gain Amplifier Path 50Ω Load1.0M 10.

Strany 42 - Physical

© National Instruments Corporation 7 NI 5441 SpecificationsFigure 3. Frequency Response of Direct Path, 100 MS/s, 1x DAC InterpolationNoteAbove 50 MH

Strany 43 - Technical Support Resources

NI 5441 Specifications 8 ni.comSpecification Value CommentsSuggested Maximum Frequencies for Common FunctionsFunction Path Disable the Analog Filter a

Strany 44 - 373846A-01 Feb05

© National Instruments Corporation 9 NI 5441 SpecificationsSpurious-Free Dynamic Range (SFDR) with HarmonicsPath Amplitude –1 dBFS.Measured from DC to

Komentáře k této Příručce

Žádné komentáře